Syclone V6-262 4.3L Turbo (1991)
Removing The Shaft Seal Seat 0-Ring
4. O-ring seal (10) using J 9553-01.
Inspect
-
Make sure the compressor neck area is clean.
-
All parts. Replace as necessary.
Install or Connect
Tools Required:
J 33011 O-Ring Seal Installer
J 23128-A Seal Seat Remover and Installer
J 34614 Shaft Seal Protector
J 5403 External Snap Ring Pliers
-
Dip the new O-ring seal in clean 525 viscosity refrigerant oil.
-
J 34614 onto the shaft (20).
Installing The Seal Seat O-Ring
1. O-ring seal using J 33011.
-
Insert J 33011 into the compressor neck until the installer "bottoms."
-
Lower the movable slide of J 33011, releasing the O-ring seal into the lower groove.
-
Rotate J 33011 to seat the O-ring seal and remove J 33011.
2. Shaft lip seal using J 23128-A.
-
Dip the shaft lip seal in clean 525 viscosity refrigerant oil and install shaft lip seal on J 23128-A.
-
Bottom the shaft lip seal into the compressor neck area using J 23128-A.
-
Release and remove J 23128-A.
3. Shaft seal retaining using J 5403.
-
Install the flat side of the shaft seal retainer ring against the lip seal.
-
Remove J 34614.
Important
-
Leak test the compressor.
Clean
-
Shaft (20) and inside the compressor neck area.
4. Clutch plate and hub assembly (2).