Syclone V6-262 4.3L Turbo (1991)
Removing The Seal Cage
-
Press J 38468 against the seal spring and twist the tool until it engages the slots of the seal cage.
Install or Connect
Tools Required:
J 29640 Shaft Protector
J 38468 Shaft Seal Remover and Installer
J 38479 Seal Seat Remover and Installer
Clean
-
Seal cavity thoroughly.
a. Use R-12 refrigerant. Blow dry.
b. Wipe with a lint tree cloth and clean refrigerant oil. Blow dry.
1. J 29640 over the compressor shaft.
-
Do not touch the new seal cage (21).
2. Slots of J 38468 to the new seal cage (21).
Installing The Seal Cage
3. Seal assembly into place in the compressor seal cavity.
-
Twist J 38468 to disengage it from the cage.
4. Clean refrigerant oil to the shaft seal seat.
5. Shaft seal seat (23) with J 38479.
6. Snap ring with the flat side toward the compressor.
7. Clutch spacer shims (3).
8. Use the originals if possible to give the same gap.
9. New felt ring.
-
If the clutch was not disassembled, reinstall the clutch front plate.