Terrain FWD L4-2.4L (2010)
Installation Procedure
1. Lubricate the CMP actuator solenoid valve O-ring seals with clean engine oil.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the intake CMP actuator solenoid valve (2) and bolt, if required.
Tighten the bolt to 10 Nm (89 lb in).
3. Install the exhaust CMP actuator solenoid valve (1) and bolt, if required.
Tighten the bolt to 10 Nm (89 lb in).
4. Connect the engine wiring harness electrical connectors (2, 3) to the appropriate CMP actuator solenoid valve.
5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement (See: Intake Manifold/Service and Repair/Intake Manifold Cover
