Typhoon V6-262 4.3L Turbo (1993)
Crankshaft Main Bearing Seal: Service and Repair
Fig. 17 Installing Rear Main Oil Seal
1.
Remove transmission.
2.
Remove clutch and flywheel, if equipped.
3.
Remove rear crankshaft oil seal by placing screwdriver in notches provided and pry the seal out.
4.
After cleaning groove, apply a thin even coat of adhesive, part No. 1052621, Loctite 414 over entire surface of seal groove.
5.
Within one minute install seal using seal installer J-35621 or equivalent, Fig. 17.
6.
Reverse steps 1 and 2 to complete installation.
