V 3500 P/U 4WD V8-379 6.2L DSL (1988)
Turn Signal Switch: Service and Repair
Fig. 1 Lock plate retaining ring removal
1.
Disconnect battery ground cable and remove steering wheel as described under STEERING SUSPENSION CHASSIS AND BODY
COMPONENTS/STEERING/COMPONENT REPLACEMENT AND REPAIR PROCEDURES/STEERING WHEEL & HORN
SOUNDER.
2.
Remove instrument panel trim cover if equipped.
3.
Remove lock plate by inserting a screwdriver into lock cover slot and prying up and out.
4.
Using lock plate compressor tool J-23653-C or equivalent, Fig. 1, compress lock plate and remove retaining ring.
5.
Pull multi-function lever straight out from pivot, then disconnect electrical connector.
6.
Remove hazard warning knob, then the turn signal mounting screws.
7.
Pull switch up and free the connector. Disconnect switch from harness.
8.
Reverse procedure to install.
