gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Power and Ground Distribution > < A/C - Insufficient Cooling in High Temperatures|Page 5947
Page 6
background image

1.

Install the upper and lower insulators (2) and

(3)

on the A/C accumulator assembly (see Figure 4).

2.

Install the clamp (4) on the insulators at the overlapped position and tighten the clamp.

Revised Refrigerant Charge:

Important

When possible, use appropriate refrigerant recovery and recycling methods. Refer to Truck Service Bulletin 90-OA-22 (Corporate Number 931203R) for
equipment information.
1.

Check the refrigerant (Freon 128) pressures per service manual. If discharge pressures are high, revise the A/C charge as follows:

A Front air conditioning (C60): reduce the charge from 3.25 lbs to 3.0 lbs.

B.

Rear air conditioning (C69): Reduce charge from 5.25 lbs to 4.5 lbs.

2 Refer to section 1B of the service manual, page 1B-13, for charging and discharging procedures.
Inspection:
1.

Start the engine and check all hose connections for leaks.

2.

Place the climate control lever in the "Max A/C" position and ensure that the water valve is operating properly.

PARTS INFORMATION:
WARRANTY INFORMATION For vehicles repaired under warranty use:
Labor Operation:

T7001

Labor Time:

.7 hr

NOTE:

Labor Operation is coded to base vehicle coverage in the warranty system.

Power and Ground Distribution > < A/C - Insufficient Cooling in High Temperatures|Page 5947