Yukon/Denali 4WD V8-6.0L VIN U (2004)
5. Install the right side interior trim panel.
Front Position Sensor Replacement
Front Position Sensor Replacement
Electronic Suspension (15 series)
Removal Procedure
1. Raise and support the vehicle.
2. Disconnect the sensor harness connector from the vehicle harness connector.
3. Remove the wheel speed sensor wire from the electronic suspension control (ESC) sensor bracket.
4. Remove the wheel speed sensor wire from the ESC sensor bracket.
5. Remove the ESC sensor link bracket bolt from the upper control arm.
6. Remove the bolt from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
