Yukon/Denali XL 1500 4WD V8-6.0L VIN U (2004)
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolt to the frame.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the ESC sensor link bracket bolt to the upper control arm.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
4. Install the wheel speed sensor wire from the ESC sensor bracket.
5. Install the wheel speed sensor wire to the ESC sensor bracket.
6. Connect the sensor harness connector to the vehicle harness connector.
7. Remove the safety stands.
8. Lower the vehicle.
Front
Front Position Sensor Link Assembly Replacement - Electronic Suspension
^
Tools Required
-
J 38185 Spring Hose Clamp Pliers
Removal Procedure