Yukon/Denali XL 1500 4WD V8-6.0L VIN U (2004)
4. If replacing the left side seal and/or bearing, perform the following steps:
4.1.
Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement6.
4.2.
Place the differential carrier assembly into a vise.
Clamp only on the mounting flange of the differential carrier assembly case.
4.3.
Remove the inner axle shaft using a hammer and a brass drift.
4.4.
Install the J29369-1, 8.25 inch axle, or the J 29369-2, 9.25 inch axle (1), behind the inner axle shaft seal or the inner axle shaft bearing as
necessary.
4.5.
Install the J2619-01 (2) to the J29369-1 or the J 29369-2.
4.6.
Remove the inner axle shaft seal and/or the inner axle shaft bearing using the J 2619-01.
Installation Procedure
1. If installing the right side bearing, perform the following steps
1.1.
Install the inner axle shaft housing into a vise.
Clamp only on the mounting flange of the inner axle shaft housing.
1.2.
Install the bearing with the square shoulder in using the J 36609 (1) and the J 8092 (2).