Yukon 4WD V8-5.3L (2008)
1. Position the gasket to the BPMV (3).
2. Position the EBCM (2) to the BPMV (3).
Important: Make sure the EBCM is properly aligned to the BPMV, including the brake pressure switch. Do not force the components
together.
3. Push the EBCM squarely onto the BPMV.
Notice: Refer to Fastener Notice .
4. Install 4 new EBCM to BPMV screws (1).
Tighten the screws in a X pattern to 3 N.m (27 lb in).
5. Connect the EBCM electrical connector.
6. If installing a replacement EBCM, program the replacement EBCM. Refer to Control Module References .
7. Bleed the BPMV. Refer to Antilock Brake System Automated Bleed Procedure (Without JL4) (See: Brake Bleeding/Service and Repair)Antilock
Brake System Automated Bleed Procedure (With JL4) (See: Brake Bleeding/Service and Repair) .