Yukon 4WD V8-5.3L (2008)
4. For vehicles with RPO L76 (6.0L) perform the following steps otherwise proceed to step 9.
5. Position the oil cooler hose adapter end, if equipped.
6. Install a NEW oil cooler hose adapter gasket, if equipped.
7. Install the oil cooler hose adapter bolts (2), if equipped.
Tighten the bolts to 12 N.m (106 lb in).
8. Install the oil cooler hose bracket bolt (1), if equipped.
Tighten the bolt to 25 N.m (18 lb ft).
9. Position and install the oil pan skid plate and bolts, if equipped
Tighten the bolts to 20 N.m (15 lb ft).
10. Lower the vehicle.
11. Fill the cooling system/engine block. Refer to Cooling System Draining and Filling (Static Fill) (See: Cooling System/Service and Repair) .