Yukon Denali AWD V8-6.2L (2007)
engine OFF.
8.
Turn off the Tech 2.
9.
Turn on the Tech2.
10.
Connect the Tech 2 to the vehicle and the TIS terminal.
11.
On the TIS terminal go into SPS Programming.
12.
Select Pass Thru programming.
13.
Follow instruction on the TIS terminal. When you get to the Supported Controllers screen:
13.1. Scroll down in the top box and select RCDLR (Remote Control Door Lock Receiver).
13.2. In the lower box select Normal.
13.3. Select Next.
Important:
Some vehicles will require additional selections in the module field before you can proceed and the "Next" button is functional.
14.
When the Calibration Screen displays, select calibration 25808841 for vehicles that are NOT equipped with the remote start feature or calibration
25808842 for vehicles that are equipped with the remote start feature. After selecting a calibration, select Next.
15.
Follow the on-screen prompts until programming is completed.
16.
When programming is complete:
16.1. Turn off Tech2.
16.2. Turn the ignition switch to the OFF position.
17.
Wait 30 seconds~.
18.
Turn the ignition switch to the ON position with engine OFF.
19.
Turn on the Tech 2.
20.
Build the vehicle using the Tech 2.
21.
Using the Tech 2, navigate to Vehicle Control Systems / Module Setup / Remote Control Door Lock Receiver.
22.
Run the Copy and Paste TPM Information Procedure (F1: Step 2).
23.
Using the Tech 2, navigate to Vehicle Control Systems / Module ID Information / Remote Control Door Lock Receiver / Tire Information.
24.
Verify that the four Pressure Sensor IDs match those that were recorded in Step 5.
25.
Go into diagnostics and check for DTC codes.
26.
Clear all codes.
Programming Remote Keyless Entry Transmitters (Vehicles in Inventory)
Important:
All of the transmitters that are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single
programming sequence. Once the Invalidate All Fobs selection is made or the RCDLR module has been reprogrammed, all learned
transmitters are erased. Up to 8 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles
that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.
Program remote keyless entry transmitters.
1.
With a scan tool, access the Remote Control Door Lock Receiver Module Setup menu. Select Program Key Fobs.
