Yukon Denali AWD V8-6.2L (2007)
4. Apply 3M Automotive Adhesion Promoter 06396, or equivalent, to the underside of the reveal molding seals.
Tip
An approximate 600 mm (24 in) length of tape should allow for overlap at the top to be trimmed back leaving a tail of release liner (1) and, at
minimum, should reach the fender cut line at the bottom.
5. Apply a 600 mm (24 in) length of 3M Automotive Acrylic Plus Attachment Tape 06386 (1.14 mm (0.045 in) thick x 6.35 mm (0.25 in) wide), or
equivalent, to both sides of the windshield. Ensure the tape (1) position is centered between the windshield edge (2) and the tape/grease pencil line
(3). Do not remove the release lining from the tape yet.
6. Reinstall the reveal molding to one side by sliding the molding downward and ensuring that the top lip is engaged at the upper edge of the
windshield.
