Yukon XL 2500 2WD V8-8.1L VIN G (2004)
Tighten
Tighten the nuts to 50 N.m (37 lb-ft).
3.
Install the booster pump rod to the lever.
4.
Install the stop lamp switch to the lever.
5.
Install the booster pump rod retainer.
6.
Connect the power brake booster outlet hose, the steering gear inlet hose, and the power brake booster inlet hose.
Tighten
^
Tighten the power brake booster inlet hose to 28 N.m (20 lb-ft).
^
Tighten the steering gear inlet hose to 28 N.m (20 lb-ft).
7.
Install the master cylinder.
8.
Install the mounting nuts.
Tighten
Tighten the mounting bolts to 50 Nm (37 lb-ft).
9.
Install the electrical connectors to the electrohydraulic pump and the flow switch.
10.
Fill the hydraulic pump reservoir.
Important:
Maintain the fluid level throughout the bleed procedure.
11.
Remove the pump reservoir cap.
Important: