Yukon XL 2500 2WD V8-8.1L VIN G (2004)
23. Connect the following electrical connectors:
-
MAP sensor (1)
-
Ignition coil harness (2)
-
ECT sensor (3)
24. Install the CPA retainer at the ignition coil harness.
25. Position engine harness branch over the top of engine.
26. Connect the following electrical connectors:
-
Pressure cycling switch (1)
-
Surge tank switch (2)
-
MAP sensor (3)
27. Connect the engine harness clip to the wheelhouse splash shield.
28. Connect the engine harness clips to the studs on the front of dash.