Yukon XL 2500 2WD V8-8.1L VIN G (2004)
7. Install the transmission control lever to the manual shaft with the nut.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
8. Connect the PNP switch electrical connector (2).
9. If equipped with 4WD, install the front propeller shaft. Refer to Propeller Shaft Replacement -Front in Propeller Shaft.
10. Lower the vehicle.
11. Check the switch for proper operation. The engine must start in the park (P) or neutral (N) positions only. If proper operation of the switch can not
be obtained, replace the switch.