Yukon XL 2500 2WD V8-8.1L VIN G (2004)
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Connect the sensor link to the ball stud.
4. Connect the sensor harness connector to the vehicle harness connector.
5. Install the wheel to the vehicle.
6. Lower the vehicle.
Right
Rear Position Sensor Replacement -Electronic Suspension- Right
Removal Procedure