Yukon XL 2500 4WD V8-6.0L VIN N (2006)
Turn Signal Switch: Service and Repair
Multifunction, Turn Signal Switch Replacement
Removal Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3.
2. Remove the upper and lower trim covers.
3. Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is
coming out of the abrasion sleeve for installation purposes. Remove the wire harness assembly (1) from the wire harness strap (2).
4. Disconnect the turn signal and multifunction switch assembly connector from the SIR system coil connector.
5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
6. Remove the 2 pan head tapping screws (1) and (3) from the turn signal and multifunction switch assembly (2).
7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.
Installation Procedure