Yukon XL 2500 4WD V8-6.0L VIN N (2006)
![background image](/gmc/yukon_xl_2500_4wd/v8-6.0l_vin_n/Page-2388002.png)
6. Install the engine protection shield, if equipped.
7. Lower the vehicle.
8. Verify the wheel alignment.
Outer
Tie Rod Replacement
^
Tools Required
-
J 24319-B Universal Steering Linkage Puller
-
J 29194 Steering Linkage Installer-14 mm
Removal Procedure
1. Raise the vehicle.
Important: Use the J24319-B in order to separate all the tie rods and ball joints.
2. Remove the nut (2) from the outer tie rod ball stud (3).
3. Use the J 24319-B in order to remove the outer tie rod ball stud from the steering knuckle.
Important: Do not reuse the nut.
4. Remove the tie rod end from the shaft by loosening the jam nut.