Yukon XL 2500 4WD V8-6.0L VIN N (2006)
3. Install the upper control arm retaining bolt to the frame bracket.
Notice: Refer to Fastener Notice in Cautions and Notices.
Important: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the upper control arm retaining nut.
^
Tighten the upper control arm retaining bolts to 105 Nm (77 ft. lbs.).
5. Connect the (ESC) sensor, if equipped.
6. Lower the vehicle.
Lower
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the lower control arm retaining nuts.
3. Remove the lower control arm retaining bolt.
4. Remove the lower control arm.
Installation Procedure