Yukon XL 2500 4WD V8-6.0L VIN N (2006)
7. Insert a flat-tipped screwdriver or a small pry bar between the outer lip of the front output shaft seal and the transfer case.
8. Remove the remaining part of the front output shaft seal from the transfer case.
Installation Procedure
1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484 .
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid if necessary.
6. Install the transfer case shield, if equipped.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
^
Tools Required
-
J 45756 Output Shaft Seal Installer
Removal Procedure