Yukon XL 2WD V8-6.0L (2007)
The stop lamp switch is mounted on the brake pedal bracket. When the brake pedal is applied, the normally open stop lamp switch closes. The ECM
monitors the stop lamp signal circuit through a discrete input and a GMLAN serial data message signal from the BCM indicating the brake status.
When both signals indicate the brake pedal is applied, the ECM will disengage the cruise control system.
The Cruise Control System will disengage when the cruise control on/off switch is switched OFF. The vehicle speed stored in the memory of the
engine control module will be erased when the cruise control On/Off switch is turned OFF, or the ignition switch is turned OFF.
The Cruise Control System will disengage when the ECM detects that a driver override function has been active for approximately 60 seconds. When
the Cruise Control System has been disengaged, the ECM sends a GMLAN serial message to the instrument panel cluster (IPC) in order to turn OFF
the Cruise Engaged indicator, and to the driver information center (DIC) in order to turn OFF the CRUISE SET TO ### message.
Cruise Control Inhibited
The engine control module (ECM) inhibits the cruise control operation when any of the following conditions exist:
-
The ECM has not detected a brake pedal activation from the body control module (BCM).
-
A Cruise Control System DTC has been set.
-
The vehicle speed is less than 40.2 km/h (25 mph).
-
The vehicle speed is too high.
-
The vehicle is in PARK, REVERSE, NEUTRAL, or 1st gear.
-
The engine RPM is too low.
-
The engine RPM is too high.
-
The system voltage is not between 9-16 volts.
-
The Antilock Brake System (ABS)/Traction Control System (TCS) is active for more than 2 seconds.