Yukon XL 4WD V8-5.3L (2011)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Ring Replacement
Non-Hybrid Greater Than/Equal to 3900 KG (8600 Lb) GVW
Rear Wheel Speed Sensor Ring Replacement
Removal Procedure
Note: The wheel speed sensor ring is integral to the wheel hub and must be replaced as an assembly.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .
4. Remove the rear axle hub. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement.
Installation Procedure
1. Install the rear axle hub. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement.
2. Install the rear brake rotor. Refer to Rear Brake Rotor Replacement .
3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
Non-Hybrid Less Than 3900 KG (8600 Lb) GVW
Rear Wheel Speed Sensor Ring Replacement
Special Tools
*
J 2619-01 Slide Hammer
*
J 8092 Driver Handle
*
J 21128 Axle Pinion Oil Seal Installer
*
J 23690 Bearing Installer
*
J 45857 Tone Wheel and/or Bearing Remover
*
J 45860 Tone Ring Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair.