Yukon XL Denali 2WD V8-6.2L (2011)
1. If the starter was replaced, install the starter heat shield.
2. If the starter was replaced, snap the transmission cover onto the starter.
3. Install the starter through the wheel well opening.
4. Install the starter solenoid cable to the starter.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
5. Install the starter solenoid cable nut (1).
Tighten the cable nut to 9 Nm (80 lb in).