Yukon XL Denali 2WD V8-6.2L (2011)
Center Link: Service and Repair
Relay Rod Replacement
Special Tools
J 24319-B - Steering Linkage and Tie Rod Puller
Removal Procedure
1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement See: Body and Frame/Frame/Skid Plate/Service and Repair/Engine
Shield Replacement.
2. Remove the steering linkage shock absorber from the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement See:
Steering Damper/Service and Repair.
3. Remove the steering linkage outer tie rods. Refer to Steering Linkage Outer Tie Rod Replacement See: Tie Rod/Service and Repair/Steering
Linkage Outer Tie Rod Replacement.
4. Remove the idler arm nut (6).
Discard the nut.
5. Separate the idler arm (1) from the relay rod (5) using the J 24319-B - Puller.
6. Remove the pitman arm nut (4).
Discard the nut.
7. Separate the pitman arm (2) from the relay rod using the J 24319-B - Puller.
8. Remove the relay rod from the vehicle.
9. Inspect the threads and seals on all steering related components. Repair or replace the components as necessary.
Installation Procedure