Accord L4-1751cc 1800 EK1 (1982)
Buss Bar Installation
1.
Remove the plastic retainer holding the defogger wires, then disconnect the wire's connectors from the glass.
2.
Use the abrasive pad to clean any black residue from the buss bar. Apply light pressure to the pad, scrubbing the buss bar gently until it turns a
silver/gray color. Remove only enough material to assure a reasonably clean surface.
CAUTION: Take care to avoid breaking the grid lines next to the buss bar.
Buss Bar Installation Procedure
3.
Clean the buss bar and adjacent glass with a wax and grease remover (Prep-Sol, Sher-Will-Clean, etc.) or alcohol, then wipe dry with a clean
cloth.
4.
Remove the backing from the new buss bar then install it over the old buss bar beginning at the grid line nearest the roof. The new buss bar
should overlap the inboard edge of the old one by 1-2 mm, as shown.
NOTE:
The new buss bars are slightly curved; make sure the curvature of the buss bar conforms to the curvature of the window edge.
