Accord L4-1955cc 2.0L SOHC 2-bbl (1986)
9. Position the piston seal, bushing and bushing retainer on the rear housing.
NOTE: Make sure the lip of the seal is facing in, as shown in drawing below.
Bushing Retainer Installation
10. Drive the bushing retainer in until it is 6 mm below the edge of the rear housing.
CAUTION: If you drive the retainer more than 6 mm, the piston seal may distort.
O-Ring Installation
11. Install the O-rings and through bolts on the rear housing and secure with 19 mm snap ring.
Fig. 12 Aligning Booster Piston To Rear Housing
12. Install the booster piston on the rear housing aligning their tabs and slots.