honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Navigation/Voice Recognition System - Operation|Page 7074 > < Navigation/Voice Recognition System - Operation|Page 7072
Page 3
background image

^

Make sure the correct screen is displayed for the voice command you are giving. Refer to the Navigation System Manual.

^

Close the windows and the moonroof.

^

Set the fan speed to low (1 or 2).

^

Adjust the air flow from the vents so that it does not blow against the microphone on the ceiling.

^

After pressing the TALK button, wait for the beep, then give a voice command.

^

Give a voice command clearly in a natural speaking voice without pausing between words.

^

If the system cannot recognize your voice command, speak louder.

^

If the microphone picks up voices other than yours, the system may not interpret your voice commands correctly.

^

If you speak a command with something in your mouth, or your voice is too husky, the system may not interpret your voice commands correctly.

NAVIGATION SYSTEM OPERATION

Selecting a Destination

A destination can be selected by Address, Intersection, Place, Personal Address, Previous Destination, Map Input, or Today's Destinations using the
touch-screen, the joystick, or the voice control system. Refer to the Navigation System Manual for detailed information.

Traveling to a Destination

Confirm a selected route - The system display asks you to select one of the following route options:

^

Direct Route - Takes the least amount of time

^

Easy Route - Minimizes the number of turns

^

Minimize Freeways - Avoids freeway travel (when possible)

^

Minimize Toll Roads - Avoids toll roads (when possible)

^

Maximize Freeways - Incorporates freeway travel (when possible)

Going off the route - If you leave the route, the system recalculates the route from your current position and displays a new highlighted route.

Modifying the route - The system can recalculate portions of the route and/or avoid a specific street, and then return you to the current route.

Save current location - This option stores the current location for later use (it does not change or cancel the route instructions currently in progress). A
location can be stored any time the navigation system is in use.

Track off-road position - This option displays small circular dots ("bread crumbs") on the map if you drive on a road not shown on the navigation screen.
These bread crumbs begin to appear approximately 1/2 mile away from a mapped road, and they allow you to retrace your route back to a mapped road.
They will not appear if this feature is turned off during setup.

Personal addresses

Two users can each store up to 100 destinations (addresses with phone numbers) in the system. A PIN (Personal Identification Number) is optional.
Refer to the Navigation System Manual for instructions on how to enter a PIN and use Personal Addresses.

Go Home

This option allows a single button entry to set your home address as a destination. A PIN is optional.

System Limitations

Always verify the audio and visual route information by carefully observing roadway signs, signals, etc. Use your own good judgment, and obey traffic
laws while driving. The navigation system has these limitations:

^

The GPS (global positioning system) satellites used by the navigation system are operated by the U.S. Department of Defense. For security reasons,

Navigation/Voice Recognition System - Operation|Page 7074 > < Navigation/Voice Recognition System - Operation|Page 7072