Accord L4-2.4L (2005)
4.
If the system does not initialize, a second screen appears. When this screen is displayed, the system is still performing the initialization. The
system does not automatically exit to the globe screen when initialization is complete. After 30 minutes, try restarting the vehicle to see if the
navigation system completed the initialization. If not, follow the instructions on the screen.
NOTE:
The initialization screen may appear after battery voltage to the navigation control unit has been disconnected for more than 5 minutes. If this
occurs, follow the on-screen instructions. If you are still unable to obtain GPS initialization, refer to the service manual for diagnostic
information.
5.
When initialization is complete, the disclaimer screen appears. Touch "OK."
NOTE:
Do not enter a destination yet. In order for the system to calculate a route, it must align the current location to a mapped road (map matching).
This will occur when you start driving.
6.
Drive the vehicle at least a half mile from your dealership, then find a safe place to park.
7.
*From the Map screen, press and release the TALK button and say "Find the nearest Honda dealer."*
8.
Select your dealership from the screen listings, then select "K" on the next screen.
NOTE:
If your dealer location is not correct or needs to be changed, please report it to your District Parts and Service Manager(DPSM).
9.
If your dealership is in a detailed coverage area, the map will show a blue highlighted route. Follow the voice guidance back to the dealership. If
your dealership is not in a detailed coverage area, you may see a blue dotted "vector line" pointing to your dealership instead of the blue
highlighted route. Exercise caution, and use the map to guide you back.
10.
While in the Map screen, verify that the voice control system is interfacing properly with the navigation, audio, and climate control subsystems.
^
*Press the TALK button on the steering wheel and say the commands "Display 1/2 mile scale" and "Display current location." If necessary,
press the BACK button (also on the steering wheel) to return to the map.*
^
To check the audio system, press the TALK button and say, "Radio play," then "Radio select AM" or "Radio select FM 1."
^
To check the climate control system, press the TALK button and say Temperature up," and then "temperature down." Verify that the
temperature display on the center console changes accordingly.
11.
Touch the SETUP button, or use the voice control system and say Setup." Then verify these settings by touch or with the joystick:
^
*Volume set to a comfortable level
^
Display set to AUTO
^
Voice feedback set to ON
12.
In Setup, touch "Delete Previous Destinations" to bring up the Select item to delete:" menu. Select and delete any previous destinations except
your dealership.
NOTE:
If this bulletin is being done as part of a warranty repair, do not delete any customer information.*
NOTE:
Normally the clock in the upper display is set by the GPS and does not need adjustment (this is the factory default). However, the time may
need to be adjusted in some cases.