Accord L4-2.4L (2005)
6. Detach the inner handle cable clip (A), and disconnect the actuator connectors (B). Remove the screws, then remove the latch (C) through the hole
in the door. Take care not to bend the outer handle rod (D), cylinder rod (E), inner handle cable (F), and lock cable (G).
7. Install the latch in the reverse order of removal, and note these items:
-
Make sure the actuator connectors are plugged in property, and each rod is connected securely.
-
Make sure the door locks and opens properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Driver's: Perform the power window control unit reset procedure.