Accord L4-2.4L (2005)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to bend or scratch the headliner.
-
Be, careful not to damage the dashboard and other interior trim.
1. Remove these items:
-
A-pillar trim, both sides, 2-door without side curtain airbag, 2-door with side curtain airbag , 4-door without side curtain airbag , 4-door with
side curtain airbag
-
Ceiling light
-
Front seat belt upper anchor, both sides, 2-door 4-door
-
B-pillar lower trim, 4-door without side curtain airbags, 4-door with side curtain airbags- B-pillar upper trim, both sides, 2-door without side
curtain airbags, 2-door with side curtain airbags , 4-door without side curtain airbags , 4-door with side curtain airbags
-
C-pillar trim, both sides, 2-door without side curtain airbags, 2-door with side curtain airbags, 4-door without side curtain airbags , 4-door with
side curtain airbags page
2. From both sides, using a trim tool, release the tabs (A), then turn the sunvisor cap (B), and remove it from the bracket (C).
3. From both sides, remove the sunvisor (A) and holder (B).
1. Remove the self-tapping ET screws.