Accord L4-2.4L (2005)
Rear Shelf: Service and Repair
Trim Removal/Installation - Rear Shelf Area
Special Tools Required
KTC trim tool set SOJATP2014
2-door
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove the C-pillar trim from both sides, without side curtain airbags, with side curtain airbags.
2. Remove the rear bulkhead cover (A).
1. Pull the upper edge of the cover back to detach the hooks (B) and clips.
2. Pull the bottom edge of the cover back to detach the hooks (C) from the body flange.
3. '03-05 models: Remove the high mount brake light (A).
1. From the trunk compartment, disconnect the high mount brake light bulb socket (B).
2. Push the high mount brake light towards the rear window, and gently pry up at the back to release the front hooks (C).
3. Release the rear hooks (D), then remove the high mount brake light.