Accord L4-2.4L (2005)
and hook strips.
-
Replace any clips you removed with new ones (A). Install them with commercially available upholstery ring pliers (B).
-
Reinstall the front hook (C) and rear hook (D) of the reinforcing cloth (E) securely.
-
Use only original Honda replacement seat-back covers.
-
If equipped, make sure the recline motor harness, side airbag harness, and OPDS harness (passenger's seat) are routed properly.
Seat Cushion Cover
1. Remove the front seat.
2. With recline motor and/or side airbag: From under the seat cushion, detach the recline motor connector clip, the side airbag connector clip, and on
the passenger's seat, the OPDS unit connector clip. Release the hook springs (on some driver's seats) and the seat cushion cover from the seat
cushion frame spring, then pull the cover back, and remove the wire ties.
3. Remove these items from the front seat, then remove the seat-back, '03 model 2-door manual seat, '04-05 models 2-door manual seat, '03 model
4-door manual seat, '04-05 models 4-door manual seat, manual height adjustable seat, 2-way power seat, 8-way power seat:
-
Recline cover
-
Center cover
4. Release the hook strips (A) and retainers (B) (manual height adjustable seat) from both sides the seat cushion.
NOTE: Manual height adjustable seat is shown; other seats are similar, except for the height ratchet unit portion.
5. Pull back the seat cushion cover (A), and release the hooks (B) from under the seat cushion. On manual height adjustable/2-way power seat, detach
the clips from the seat cushion frame (C).
6. Remove the cushion cover/pad from the seat cushion frame.