Accord L4-2.4L (2005)
Seat Latch Cable: Service and Repair
Rear Seat Access Cable Replacement
2-door Driver's Seat
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Take care not to tear the seams or damage the seat covers.
-
Take care not to bend the cable.
-
Put on glove protect your hands.
1. Remove the front driver's seat.
2. Remove the seat-back.
3. Remove the seat-back cover/pad as an assembly from the seat-back frame.
4. Detach the cable clip (A), and disconnect the rear seat access cable (B) from the rear seat access lever (C) and both recline adjusters (D). Release
the wire ties (E), then remove the cable.
5. Install the cable in the reverse order of removal, and note these items:
-
Replace any wire ties you removed with new ones.
-
To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hooks.