Accord L4-2.4L (2005)
Braking Sensor/Switch: Adjustments
Brake Pedal and Brake Pedal Position Switch Adjustment
Pedal Height
1. Turn the brake pedal position switch (A) counterclockwise, and pull it back until it is no longer touching the brake pedal.
2. Lift up the carpet. At the insulator cutout, measure the pedal height (B) from the left side of the pedal pad (C).
Standard pedal height (with carpet removed):
M/T: 167 mm (6 9/16 inch)
A/T: 172 mm (6 13/16 inch)
3. Loosen the pushrod locknut (A), and screw the pushrod in or out with pliers on the knurled part of the push rod (B) until the standard pedal height
from the floor is reached. After adjustment, tighten the locknut firmly. Do not adjust the pedal height with the pushrod pressed.
4. Push in the brake pedal position switch until its plunger is fully pressed (threaded end (A) touching the pad (B) on the pedal arm). Then, turn the
brake pedal position switch 45° clockwise to lock it. The gap between the brake pedal position switch and the pad is automatically adjusted to 0.4
to 3.0 mm (0.016 to 0.118 inch) by locking the switch. Make sure the brake lights go off when the pedal is released.