Accord L4-2.4L (2005)
Electronic Brake Control Module: Service and Repair
ABS Modulator-Control Unit Removal and Installation
NOTE:
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
Be careful not to damage or deform the brake lines during removal and installation.
^
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
Removal
1. Pull up the lock (A) of the ABS modulator-control unit 25P connector (B), and the connector disconnects itself.
2. Disconnect the six brake lines from the ABS modulator-control unit (C).
3. Remove the five 6 mm bolts and the one hex bolt.
4. Remove the ABS modulator-control unit.
Installation
1. Install the ABS modulator-control unit, then tighten the five 6 mm bolts and the one hex bolt.
2. Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
3. Align the connecting surface of the ABS modulator-control unit 25P connector to the ABS modulator-control unit.
4. Push in the lock (A) of the ABS modulator-control unit 25P connector (B) until you hear it click into place.