Accord L4-2.4L (2005)
12. Apply a thin coat of M-77 assembly paste (P/N 08798-9010) to the pad side of outer pad shim C, inn~r pad shim B, both sides of inner pad shim
A, the back of brake pads (D), and to the other areas indicated by the arrows. Wipe excess assembly paste off the pad shims and brake pads.
Contaminated brake discs and pads reduce stopping ability. Keep assembly paste off the brake discs and brake pad material.
13. Install the brake pads and pad shims correctly.
Install the brake pads with the wear indicator (E) on top.
If you are reusing the brake pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
14. Push in the piston (B) so the caliper will fit over the brake pads. Check the brake fluid level. The brake fluid may overflow if the reservoir is too
full. Make sure the piston boot is in position to prevent damaging it when pivoting the caliper down.
15. Pivot the caliper (C) down into position. lnstall the flange bolt (D), and tighten it to the specified torque while holding the pin A with a wrench
being careful not to damage the pin boot.
16. Install the brake hose mounting bolt (A), and tighten it to the specified torque.