Accord L4-2.4L (2005)
6. Clean both balancer shaft No. 2 journals and bearing halves with a clean shop towel.
7. Place one strip of Plastigage across each, No. 2 journal.
8. Reinstall the bearings and upper balancer shaft holder, then- torque the bolts.
NOTE: Do not rotate the balancer shafts during inspection.
9. Remove the upper balancer shaft holder and bearings again, and measure the widest part with the Plastigage. If the balancer shaft No. 2 journal oil
clearance is out-of-tolerance, install new bearings, and recheck. If it is still out-of-tolerance, replace the balancer shafts.