Accord L4-2.4L (2005)
Piston: Testing and Inspection
Block and Piston Inspection
1. Remove the crankshaft and pistons.
2. Check the piston for distortion or cracks.
3. Measure the piston diameter at a point 13 mm (0.5 inch) from the bottom of the skirt. There are two standard-size pistons (No Letter or A, and B).
The letter is stamped on the top of the piston. Letters are also stamped on the block as cylinder bore sizes.
4. Measure wear and taper in direction X and Y at three levels in each cylinder as shown. If measurements in any cylinder are beyond the Oversize
Bore Service Limit, replace the block. If the block is to be rebored, refer to step 7 after reboring.