Accord L4-2.4L (2005)
Oil Filter: Service and Repair
Engine Oil Filter Replacement
Special Tools Required
Oil filter wrench 07HAA-PJ70100
1. Remove the oil filter with the special tool.
2. Inspect the threads (A) and rubber seal (B) on the new filter. Clean the seat on the engine block, then apply a light coat of new engine oil to the
filter rubber seal. Use only filters with a built-in bypass system.
3. Install the oil filter by hand.
4. After the rubber seal seats, tighten the oil filter clockwise with the special tool.
5. If four numbers or marks (1 to 4 or V to VVVV) are printed around the outside of the filter, use the following procedure to tighten the filter.
^
Spin the filter on until its seal lightly seats against the block, and note which number or mark is at the bottom.
^
Tighten the filter by turning it clockwise three numbers or marks from the one you noted. For example, if number 2 is at the bottom when the
seal is seated, tighten the filter until the number 1 comes around the bottom.