Accord L4-2.4L (2005)
Compressor Clutch: Testing and Inspection
Compressor Clutch Circuit
Compressor Clutch Circuit Troubleshooting
NOTE:
-
Do not use this troubleshooting procedure if the fans are also inoperative. Refer to the symptom troubleshooting index. See: Testing and
Inspection/Symptom Related Diagnostic Procedures
-
Before performing symptom troubleshooting, check for powertrain DTCs.
1. Check the No.12 (7.5 A) fuse in the under-hood fuse/relay box, and the No.30 (7.5 A) fuse in the under-dash fuse/relay box.
Are the fuses OK?
YES - Go to step 2.
NO - Replace the fuse(s), and recheck.
2. Check the engine coolant temperature, throttle position, and idle speed (use the HDS PGM-FI data list if possible).
Is the coolant temperature, throttle position, and idle speed OK?
YES - Go to step 3.
NO - Troubleshoot and repair the cause of the high engine coolant temperature, low idle, or excessively high throttle position sensor reading.
3. Remove the compressor clutch relay from the under-hood fuse/relay box, and test it.
Is the relay OK?
YES - Go to step 4.
NO - Replace the compressor clutch relay.
4. Measure the voltage between the No.1 terminal of the compressor clutch relay 4P socket and body ground.
Is there battery voltage?
YES - Go to step 5.
NO - Replace the under-hood fuse/relay box.