Accord L4-2.4L (2005)
Information Bus: Reading and Clearing Diagnostic Trouble Codes
Reading Diagnostic Trouble Codes
How to display DTC on the gauge control module
1. While in Test Mode 1, the DTCs which have been detected and stored individually by various B-CAN (Body-controller Area Network) units, will
be shown one by one on the ODO display when the communication between the Multiplex Integrated Control Unit (MICU) and the gauge control
module is normal. To scroll through the DTCs, press the RESET knob on the gauge control module.
Clearing Diagnostic Trouble Codes
How to clear the DTC
1. While in Test Mode 1, press and hold down the RESET knob for more than 10 seconds.
2. The unit that has stored the code can be identified by the number shown on the trip display.