Accord L4-2.4L (2005)
8. Remove the center lower covers (A).
9. Remove the duct (B).
10. Disconnect the PCM connectors (C).
11. Remove the bolts (D), then remove the PCM (E).
12. Install the known good PCM in the reverse order of removal.
13. Open the SCS line with the HDS.
14. Turn the ignition switch ON (II).
NOTE:
'05-07 models: DTC P0630 "VIN Not Programmed or Mismatch" may be stored because VIN has not been programmed into the PCM; ignore it,
and continue this procedure.
15. '05-07 models: Manually input the VIN to the PCM with the HDS.
16. Update the PCM if it does not have the latest software.
17. Select the IMMOBI SYSTEM with the HDS.
18. Enter the immobilizer code with the PCM replacement procedure in the HDS; it allows you to start the engine.
19. Reset the PCM with the HDS.
20. '06-07 models: If the TP POSITION CHECK failed in step 5, clean the throttle body.
21. Do the PCM idle learn procedure.
22. Do the CKP pattern learn procedure.