Accord L4-24L (2005) Driver Side Air Bag Protector Installation Recall
12.
Turn the inflator over (airbag side down), and reinstall it into the airbag cover:
^
Make sure there is no debris inside the cover.
^
Insert the top of the inflator into the cover, and attach the upper hooks.
^
Press the bottom of the inflator into the cover, and attach the lower hooks.
13.
Align the inflator and the horn contact brackets, and make sure the horn springs move freely.
*14. Connect the horn switch 1P connector, and reinstall the airbag with new Torx bolts. Using a T-30 Torx bit, torque the bolts to 9.8 N.m (7.2 lb-ft).
NOTE:
Do not use the fastener extractor to install the airbag bolts.*
15.
Connect the driver's airbag 4P connector to the cable reel, then reinstall the access panel to the steering wheel.
16.
Reconnect the negative cable to the battery, turn the ignition switch to ON (II), and watch the SRS indicator.
^
If the indicator comes on for about 6 seconds, and then goes off, go to step 17.
^
If the indicator does not come on or stays on, troubleshoot the SRS (see section 23 of the 2003-05 Accord Service Manual).
17.
Make sure the horn works.
18.
Enter the anti-theft code for the audio unit and, if equipped, the navigation system.
19.
Enter you customer's audio presets. On non-navi vehicles, set the clock.