Accord L4-2.4L (2005)
Air Bag Control Module: Service and Repair
Front Passenger's Weight Sensor Unit Replacement
Front Passenger's Weight Sensor Unit Replacement
NOTE: Review the seat replacement procedure in the body section before performing repair or service.
Removal
1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio preset buttons.
2. Slide the seat all the way to the rear.
3. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
4. Disconnect the front passenger's airbag 4P connector.
5. Disconnect the connectors. Remove the mounting nuts (A) and the front passenger's weight sensor unit (B) from the seat riser.
Installation
NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.
1. Place the new front passenger's weight sensor unit on the seat riser. Tighten the two mounting nuts (A) and connect the connectors.
2. Reconnect the front passenger's airbag 4P connector.
3. Reconnect the battery negative cable.
4. Calibrate the front passenger's weight sensor unit.
5. After installing the front passenger's weight sensor unit, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator
should come on for about 6 seconds and then go off.
6. Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets, and set the clock.