Accord L4-2.4L (2005)
Seat Belt: Service and Repair
Front Seat Belt
Front Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE: Check the front seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
Front Seat Belt - 2-door
1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio preset buttons.
2. Slide the front seat forward fully.
3. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
4. Remove the seat belts.
-
'03 model driver's and passenger's seat belts and '04 model driver's seat belt: Remove the lower anchor cap (A), and remove the lower anchor
bolt (B).
-
'04 model passenger's seat belt: Carefully insert the tip of a small screwdriver (A) through the hole in the back of the front seat belt lower
anchor cover (B) and into the hole in the front seat belt lower anchor (C).
Unlock the lower anchor by pushing in on the screwdriver. Remove the screwdriver, and then detach the front seat belt anchor plate (D) and
anchor cover from the lower anchor.
5. Remove these items:
-
Side trim panel.
-
Middle cross-member gusset.