Accord L4-2.4L (2005)
Technical Service Bulletin # 07-002
Date: 070120
Recall - Replace Driver's Seat Position Sensor Harness
07-002
January 20, 2007
Applies To:
See VEHICLES AFFECTED
Safety Recall:
Driver's Seat Position Sensor Harness Replacement (Supersedes 07-002, dated January 19, 2007, to update the information marked by asterisks)
BACKGROUND
*Because of an improperly routed driver's seat position sensor harness and an overtightened wire tie, the seat position sensor harness may be damaged.
This may cause the SRS indicator to stay on with DIG 71 -1x ("x" can be 0 thru 9 or A thru F) and result in the seat position sensor not being able to
detect the seating position of the driver. This could affect the inflation pressure of the driver's front airbag.*
VEHICLES AFFECTED
2004 Accord EX L4 - Some HAM-produced vehicles equipped with Setex 8-way power seat
2004 Accord LX V6 - Some HAM-produced vehicles equipped with Setex 8-way power seat
2004 Accord EX V6 - Some HAM-produced vehicles equipped with Setex 8-way power seat
2005 Accord EX L4 - HAM-produced vehicles equipped with Setex 8-way power seat from VIN 1HGCM5...5A000001 thru 1HGCM5...5A025841
2005 Accord LX V6 - HAM-produced vehicles equipped with Setex 8-way power seat from VIN 1HGCM6...5A000001 thru 1HGCM6...5A011681
2005 Accord EX V6 - HAM-produced vehicles equipped with Setex 8-way power seat from VIN 1HGCM6...5A000001 thru 1HGCM6...5A011860
Only a small number of vehicles within a wide range of vehicles are affected by this safety recall. Before beginning work, verify vehicle eligibility by
checking at least one of these items:
^
The customer has a notification letter.
^
The vehicle is shown on your campaign responsibility report.
^
The vehicle is shown as eligible on a VIN status inquiry.
^
Confirm that the vehicle is equipped with an 8-way power seat by verifying the Setex tag, located on the inboard side of the seat (next to the center
console).
In addition to these verification items, check for a punch mark above the seventh character of the engine compartment VIN. A punch mark in that
location means the driver's seat position sensor harness has been replaced.
Some vehicles affected by this campaign may be in your used vehicle inventory. According to federal law, these vehicles cannot be sold or leased until
they are repaired. To see if a vehicle is affected by this campaign, do a VIN status inquiry before selling it.
CUSTOMER NOTIFICATION
All owners of affected vehicles will be sent a notification of this campaign. An example of the customer notification is at the end of this service bulletin.
CORRECTIVE ACTION
Replace and reroute the driver's seat position sensor harness.
PARTS INFORMATION
Driver's Seat Position Sensor Harness:
P/N 81 607-SDA-L70, H/C 7465073
Wire Ties (enough to repair 10 vehicles):
P/N 90650-KV3-000, H/C 4977930