Accord L4-2.4L (2005)
Refrigerant Pressure Sensor / Switch: Testing and Inspection
Manual HVAC
A/C Pressure Switch Circuit Troubleshooting
NOTE:
-
Do not use this troubleshooting procedure if the following items are operative; condenser fan, radiator fan, A/C compressor, or if the heater is
inoperative, Refer to the symptom troubleshooting index. See: Heating and Air Conditioning/Testing and Inspection/Symptom Related Diagnostic
Procedures
-
Before performing symptom troubleshooting, check for powertrain DTCs.
1. Check for body DTCs in test mode A of the MICS.
Are the any DTCs indicated?
YES - Do the appropriate troubleshooting for the DTC indicated.
NO - Go to step 2.
2. Disconnect the A/C pressure switch 2P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between the No.1 terminal of the A/C pressure switch 2P connector and body ground.
Is there 5 V or more?
YES - Go to step 5.
NO - Go to step 13.
5. Turn the ignition switch OFF.
6. Check for continuity between the No.1 and No.2 terminals of the A/C pressure switch.
Is there continuity?
YES - Go to step 7.
NO - Go to step 14.