Accord L4-2.4L (2005)
11. Remove the ATF dipstick, and remove the bolts securing the ATF cooler inlet line brackets (A) and ATF dipstick guide pipe (B) from the
transmission hanger (C).
12. Remove the harness clamp (D), then remove the ATF dipstick guide pipe.
13. Disconnect the shift solenoid harness connector.
14. Remove the shift solenoid valve cover (A), dowel pins (B), and gasket (C).
15. Remove the shift solenoid harness connector.
16. Measure ATF temperature sensor resistance between shift solenoid harness connector terminals No. 6 and No. 7.
Standard: 50 Ohms - 25 k Ohms
17. If the resistance is out of standard, replace the ATF temperature sensor and solenoid harness; go to step 18. The ATF temperature sensor is not
available separately from the solenoid harness. If the measurement is within the standard, install the removed parts; go to step 20.
18. Disconnect the connectors from the shift solenoid valves.