Accord L4-2.4L (2005)
79. Bend the lock washer (A) back against the flat spots on the rack end joint housing.
80. Apply multipurpose grease to the circumference of the rack end joint housing (A).
81. Apply a light coat of silicone grease to the boot grooves (B) on the rack ends.
82. Center the steering rack within its stroke.
83. Clean off any grease or contamination from the boot installation grooves (A) around the gearbox housing. Install the boots (B) on the rack ends
with the tie-rod clips (C), and fit the boot end in the installation grooves in the housing properly.
84. After installing the boots, wipe any grease off the threaded section (D) of the rack end.